Zanussi ZXC 78/31 Instruction Booklet page 9

Remove the little plates and make the holes with a
diam. of 2 mm. Replace the little plates over the
runners and screw in the screws provided
(3.5x16 mm).
For the alignment of the kitchen unit door, if
necessary, use the clearance size of the slotted holes.
At the end of the procedure, check that the doors of
the appliance and the kitchen unit open properly.
PR35
If the appliance is fixed to the side of the kitchen
unit, simply slacken the screws in fixing brackets
(F), move the brackets as shown in the figure and
re-tighten the screws.
Then fit cover (G).
D370
Fig. 10
Fig. 11
F
G
9