Access Codes - Nokia 2112 User Manual

Set up security level
1. At the standby screen, select
Menu > Settings
settings > Security
press Select.
2. Enter the security code and press
OK.
3. Scroll to None, Memory, or
and press Select.
None — Owner and Non-owner
cards are treated the same.
Memory — Non-owner cards can
access UIM memory. Any changes
to the memory setting requires
the security code. The owner card
has access to all features, but the
security code is required to
change a memory setting
Phone — The security code is
required upon power-up.
4. A message appears in the display
confirming your selection.

Access codes

Note: Avoid using codes similar to
emergency numbers such as 911 to
prevent accidental dialling of the
emergency number.
The security code controls access to
features such as the security level
and is supplied with the phone. The
preset code is 12345. Once you
change the security code, keep the
new code secret and in a safe place
separate from your phone.
> Security
level, and
Phone
Copyright © 2004 Nokia. All rights reserved.
S e t t i n g s ( M e n u 4 )
Note: If you enter the wrong security
code five times in succession, you
will not be able to enter a code for
five minutes, even if you power off
the phone between incorrect entries.
Change security code
1. At the standby screen, select
Menu > Settings
settings > Access codes
security code, and press Select.
2. Enter the current security code
(default is 12345), and press OK.
3. Enter the new security code (up
to 10 characters) and press OK.
4. Reenter the new security code for
verification, and press OK.
Note: When you change your
security code, make sure you store it
in a safe place, away from your
phone. Avoid entering access codes
similar to emergency numbers to
prevent accidental emergency calls.
Change PIN Code
Before you can change your PIN
code, you'll need to enable PIN code
request. See "PIN code" on page
1. Press Menu > Settings
settings > Access codes
PIN code
2. Enter the current PIN code and
press OK.
3. Enter the new PIN code and press
OK.
> Security
> Change
52.
> Security
> Change
53