Assembly; Operating Instructions - Oreck U2000RB-1 User Manual

A
ssembly
To assist you in identifying components of your vacuum, the parts
have been numbered as follows:
1 Handle section, upper
2 Tube, lower
3 Power head
4 Outer bag
5 Paper filter
dust bag
6 Power cord
7 Retaining
spring
8 Bag tension
bar
5
9 Zip fastener
10 ON/OFF
switch
11 Cord hook
12 Plastic loop/cable clamp
13 Connector Assembly/
Rear Carry Handle
14 Fan housing
15 Cord assembly
16 Cord-Lock
17 Pigtail
1
Upper
2
Handle
Connector

Assembly

E N
10
9
12
13
4
2
7
8
14
3
Before assembling appliance,
remove two screws from the
connector assembly. Remove
plastic insert by pulling
upward.
With ON/OFF switch facing the
front of the unit, slide upper
handle section over matching
section of the connector assembly.
Place brace against handle and
connection assembly aligning the
holes. Insert one screw into top
hole and one screw into the
bottom hole then tighten firmly
until handle is no longer loose.
G L I S H
3
17
11
1
O
perating
16
To Operate
Make sure disposable paper filter dust bag is in place. DO NOT
operate the cleaner without a paper filter dust bag. Plug the power
cord into an electrical outlet and press the ON (l) - OFF (O) switch
6
on Helping Handle Assembly, or on top of base for Straight Handle
Models when ready to operate.
General Information
The performance of your new cleaner greatly depends upon care
and maintenance. The instructions in this manual will guide you in
15
performing basic care and maintenance. To obtain the most satis-
fying years of service read the instructions and keep them handy
for future reference.
Operating Recommendations
This new ORECK XL High-Speed Upright gets under things, and it's
SO lightweight and easy to use.
The following are a few simple suggestions regarding its operation:
1. When inserting a new disposable paper filter dust bag—
FIRST PUFF OUT and OPEN THE BAG.
2. When the disposable filter dust bag is full, REPLACE IT.
3. If at any time the machine does not pick up properly or makes
an unusual noise, STOP OPERATION and service.
4. Although your upright will pick up pins, paper clips, and other
small objects, it is recommended that these be removed from
the floor before you vacuum. Failure to do so may result in
permanent damage to the motor suction fan and its housing.
5. WARNING: Do not use your vacuum cleaner on damp or
wet surfaces. This will cause damage to the vacuum cleaner
and is dangerous to the user. Damage caused by use on wet
or damp surfaces is not covered under warranty.
6. Change the disposable filter dust bag at least once a month—
even if it is not full! The collected dust in the dust bag can
cause odor, attract moisture, act as a breeding area and can
affect the efficiency of the cleaner.
7. DO NOT run the vacuum cleaner over cord. The revolving
brush could damage the cord.
8. Use caution when vacuuming over area rug edges & fringe.
Disposable Paper Filter Dust Bags
Disposable paper filter dust bags play a very important role in the
4
Attach cord to cord clip by
pressing cord above and
below clip ensuring the cord
is fully rested in clip.
I
nstructions