Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Oreck XL U2000RB2L-1
Summary of Contents for Oreck XL U2000RB2L-1
- Page 1 S I M P L Y A M A Z I N G ® ’ UIDE COMMERCIAL U2000RB2L-1 HIGH SPEED UPRIGHT VACUUM CLEANER WITH ® CLEANING SYSTEM •IMPORTANT• SAVE THIS BOOKLET! Includes: • Safety Warnings • Warranty • Operating Instructions •...
-
Page 2: Table Of Contents
US: 1-800-989-3535 Your ORECK vacuum cleaner is a product of precise engineering. Canada: 1-888-676-7325 The motor bearings are permanently lubricated and should not be oiled. If you require additional information or have problems with •... -
Page 3: Important Safety Instructions
Important Grounding Instructions Safety InStructIonS This appliance must be grounded. If the appliance should malfunction or breakdown, • Do not operate the vacuum when it is in grounding provides a path of least resistance the upright and locked position. for electric current by reducing the risk of electric shock. - Page 4 If you purchase this product from any other source, your purchase is “AS IS,” which means Oreck grants you no warranty, and that you, not Oreck, assume the entire risk of the quality and performance of this product, including the entire cost of any necessary servicing or repairs of any defects.
-
Page 5: Operating Instructions
Operating Recommendations The vacuum cleaner motor bearings are factory lubricated and This new ORECK XL High-Speed Upright is one of the finest, fastest, sealed. Further lubrication is not required. and strongest units in its class. You’ll love the way it cleans, gets under things, and it’s SO lightweight and easy to use. -
Page 6: Fresh Air ® Tab
NOTE: If the above actions do not correct the problem, contact does not fluff up or balloon open, follow the following steps: an ORECK authorized service center or call the commercial customer service center. WARNING: Unplug cord from electrical Commercial: 1-800-242-1378 outlet before servicing. -
Page 7: To Adjust Or Replace Brush, Troubleshooting Guide
“NEW” should be ordered. position. When rotating, both ALL OTHER SERVICING SHOULD BE DONE BY AN bearings must be in ORECK AUTHORIZED SERVICE CENTER. the “OLD” position. CALL COMMERCIAL CUSTOMER SERVICE HOT LINE Unmatched settings Commercial: 1-800-242-1378 will cause damage Hospitality: 1-888-23-ORECK to your machine. - Page 8 ©2014 Techtronic Floor Care Technology Limited. All word marks, logos, product configurations, and registered trademarks are owned 76209-02 and used under the authority of Techtronic Floor Care Technology Limited...
Need help?
Do you have a question about the XL U2000RB2L-1 and is the answer not in the manual?
Questions and answers