Table of Contents
Advertisement
WIreless seTUP
sections
table of contents
There are three ways to attach your Home Base to your wireless
network:
•
Wired Setup of Wireless Mode
•
WPS Push Button Configuration
•
WPS PIN Configuration
Home Base
1
2
3
4
5
6
7
8
Wired setup of Wireless Mode
note: If Home Base is powered on while plugged into a router, it will
operate as a wired device. To enable Wireless mode, follow instructions
below.
The setup software will help you make Home Base operate as a member
of your wireless network.
1 .
Start by connecting your Home Base to your router. (You'll unplug
it later.)
2 .
Connect the AC adapter.
3 .
Run the setup software and follow the software's instructions to set
up the Home Base.
4 .
When offered wireless setup, select a wireless network.
5 .
The setup software will tell Home Base what network you chose.
Follow the software's instructions to unplug your Home Base from
the router and turn it off and on.
6 .
Your Home Base will then operate as a member of your wireless
network.
5
9
10
11
12
13
14
15
Advertisement
Table of Contents
