Door Reversibility; Electrical Connection; Technical Specification - Zanussi ZD 19/5 R Instruction Booklet

Door reversibility

Unplug the refrigerator from the wall socket before
performing the following operations:
Remove the lower hinge (1) and the support foot (2).
Unscrew the front left support foot (3) and screw it
into the corresponding position on the opposite side.
Unscrew the two screws which hide the fixing holes
of the hinge on the left-hand side.
Detach the lower door from the central hinge (4).
Remove the central hinge and detach the upper door
from the pin (5). Unscrew the pin (5) and screw it into
the corresponding position on the opposite side.
After having removed the plug which must be refitted
on the other side, re-assemble the upper door, the
central hinge and the lower door.
Re-assemble the lower hinge (1) and the support foot
(2) on the opposite side.
Attention
After completion of the door reversibility operation,
verify that the door gasket is adherent to the cabinet.
If the ambient temperature is cold (i.e. in Winter), the
gasket may not fit perfectly to the cabinet. In that
case, wait for the natural fitting of the gasket or
accelerate this process by heating up the part involved
with a normal hairdrier.

Electrical connection

Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply.
Voltage can vary by 6% of the rated voltage.
For operation with different voltages, a suitably sized
auto-transformer must be used.
The technical data is indicated in the rating plate on the left side inside the appliance.
48
TECHNICAL SPECIFICATION
3
D586
Fig. 3
5
4
1
2
GB