Ice-Cube Production - Zanussi ZD 19/5 R Instruction Booklet

Fridge-freezer zd 19/5 r

Hide thumbs Also See for ZD 19/5 R:

Instruction booklet (9 pages)

Table Of Contents

Table of Contents

The freezer compartment, however, will become

progressively covered with frost. This should be

removed with the special plastic scraper provided,

whenever the thickness of the frost exceeds 4 mm.

During this operation it is not necessary to switch off

the power supply or to remove the foodstuffs.

However, when the ice becomes very thick on the

inner liner, complete defrosting should be carried out

and it is advisable to carry out this operation when the

appliance is empty.

To carry out complete defrosting of the freezer

compartment (

Unplug the appliance from the power supply or set the

thermostat on the « O » position. Remove the ice-cube

trays and the frozen foods and wrap them in several

sheets of newspaper or, even better, in thermally

insulated containers, and then keep them in a cool

place.

Keep the freezer door open and introduce a container

ﬁlled with hot water (taking care to place this on a

layer of cardboard) so as to accelerate the defrosting

process.

Place a basin on the ﬁrst grill shelf in the refrigerator

directly below the drainage hole and lift up the small

lid.

Absorb all remaining water with a sponge and then

accurately dry the freezer. Reconnect the appliance to

the power supply and then set the thermostat to the

coldest position for approximately 2 hours and then

shift it into the normal functioning status.

Replace the foods previously removed from the

freezer and the ice cubes trays.

Important

Do not use a mechanical device or any artiﬁcial

means to speed up the thawing process other than

those recommended by the manufacturer.

Remember that an increase in the surface temperature

of already-frozen foods may signiﬁcantly decrease

the duration of their conservation.

) proceed as follows:

PR134