Front Panel - PROCEED AMP3 Instruction Book

PR O C E E D
PR O C E E D
12
a m p
a m p

Front Panel

1 POWER BUTTON
Pressing the latching
mains, turning it
on
proximately 140 watts for the AMP 2 and 210 watts for the AMP 3.
At your option, you may also toggle the AMP between a
and fully by connecting its
on
remote turn on output
even the CDP . Power consumption in
just a few watts for the circuitry which controls the turn-on procedure.
Note that if the amplifier has been disconnected from the AC mains
power by depressing the front panel
a remote turn-on command from a control unit.
2 INDICATOR LIGHT
The indicator light
tional status of your AMP . Amber indicates that the AMP is
to be used. When the indicator light is glowing red, the unit is in
standby (see 1 above). If the indicator light is completely off, the ampli-
fier is not receiving power. Check your AC connections and the rear-
panel AC fuse.
2 channel power amplifier
1
3 channel power amplifier
power button connects the amplifier to the AC
. Power consumption when fully on and at idle is ap-
remote turn on jack
on a Proceed control unit such as the PAV , PRE, or
standby
power
glows either amber or red, depending on the opera-
p o w e r
2
p o w e r
mode
standby
to the corresponding
mode is extremely small—
button, it cannot respond to
and ready
on