Before Use; Using Fridge; To Start The Fridge And Set The Correct Temperature; Temperature Inside The Fridge - Zanussi ZC345 Instruction Booklet

Before use

Position and clean the cabinet as explained in the
section "Installation".
Check that the drain hose at the rear of the cabinet
discharges into the drip tray.
Before inserting the power plug into the
outlet and switching on the cabinet for
the first time, leave it standing upright
for about 30 minutes, or for 4 hours if it
was transported horizontally. Otherwise
the compressor may sustain damage.
This time will allow the oil sufficient
time to return to the compressor.

Using fridge

To start the fridge and set the
correct temperature
Turn the thermostat control to the desired position.
1 :
The lowest position of the thermostat control results
in the highest temperature inside the cabinet.
6 :
The highest position of the thermostat control results
in the lowest temperature inside the cabinet.
0 :
Switched off.
Allow the cabinet to run for a period of 24 hours
whenever the temperature setting is changed. This
will allow the temperature to stabilise inside the
cabinet.

Temperature inside the fridge

A suitable temperature inside the fridge is approx.
+5°C. If the thermostat control is set to a too cold
temperature, food with a high water content may
start to freeze if it has been placed in the coldest
places in the fridge. The picture shows the coldest
and warmest places inside the fridge.
(+ warm, - cold)
Meat, fish and milk should be put in the coldest part
of the cabinet.
The temperature will be affecteed by:
· How often the door is opened
· How much food is stored
· Position of the appliance (See chapter
Installation)
+
--
--
--
--
--
+
13
GB
GB
+
--
+
Zanussi 818 14 55-01/8