Mitsubishi Electric MDT5525 User Manual page 53

OSD screen functions (continued)

GAMMA SELECTION
You can select the gamma mode from NATIVE, S GAMMA,
2.2, 2.4, OPTION, and PROGRAMMABLE.
PROGRAMMABLE can change the GAMMA characteristic
curve via a computer.
Contact your dealer for further details.
NOTE: GAMMA is fi xed to 2.2 in the sRGB picture mode.
When PROGRAMMABLE has been selected, the
setting for color temperature is fi xed at 10,000 K
(NATIVE).

SUPER RESOLUTION
NOTE: This adjustment doesn't work in the sRGB picture
mode.
[SUPER RESOLUTION]
Still photos, natural images and videos may benefi t with
enhanced resolution by adjusting this setting.
You can adjust the effect at 10 levels using the adjustment
bar (0 to 100) in 10 steps.
[RESOLUTION DETECT]
This function applies optimum effect to the input images
depending on their resolution.
You can set this item when the super resolution level is
other than 0% (off).
AUTO: The resolution of the input image is automatically
recognized and the effect suitable for the
recognized resolution is applied.
HD: The effect suitable for high resolution images is
applied.
SD: The effect suitable for standard resolution images
is applied.
LD: The effect suitable for low resolution images such
as video stream content is applied.
NOTE: The effect of the super resolution technique varies
depending on the type and resolution of the input
image. Noise or fl icker may occur depending on the
displayed content.

AUTO BRIGHTNESS
This function controls the screen brightness depending on
the ambient light for easy viewing.
In addition, it changes the screen brightness depending on
the ambient light and what are displayed on the screen to
reduce power consumption as low as possible.
NOTE: This adjustment doesn't work in the sRGB or
CINEMA picture mode.
[AUTO BRIGHTNESS]
AUTO: The settings of AUTO BRIGHTNESS are
adjusted automatically.
NOTE: When you select AUTO, you cannot
adjust any other items than [CONTROL]
individually.
LOCAL: The AUTO BRIGHTNESS function is
enabled and you can adjust [CONTROL] and
subsequent items individually.
REMOTE: The AUTO BRIGHTNESS function is
enabled. In addition, the monitor enters the
intercommunication mode where multiple
monitors are controlled collectively. (See page
60.)
OFF: This function is disabled.
[CONTROL]
PRIMARY:
SECONDARY: Select this setting to use the monitor
[LIGHT FROM BACK]
This function is enabled only when [REAR SENSOR] is ON.
When a light source such as a light and a window is behind
the monitor, the rear sensor takes precedence.
YES: Select this setting when there is a light source
such lighting equipment and a window behind the
monitor.
NO: Select this setting when there is no light source
such lighting equipment and a window behind the
monitor.
[BACK WALL]
This function is enabled only when [REAR SENSOR] is ON.
Select the following settings according to the distance
between the rear of the monitor and the wall or window.
FAR: The distance is 5 meters or longer.
NEAR: The distance is 5 meters or shorter.
[FRONT SENSOR]
Select ON for normal use.
OFF: Select this setting when the sensor on the front
panel is shielded.
[REAR SENSOR]
Select ON for normal use.
OFF: Select this setting when the sensor on the rear
panel is shielded.
[SATURATION]
ON: The image saturation is adjusted depending on the
ambient light.
OFF: Image saturation isn't adjusted.
[VIDEO DETECT]
ON: The screen brightness varies depending on what
are displayed on the screen to reduce power
consumption of the monitor.
OFF: The screen brightness doesn't vary and the power
consumption isn't reduced.

PICTURE RESET
You can reset all the PICTURE settings to the factory
defaults.
English-49
Select this setting to confi gure the monitor
as Master when controlling multiple
monitors collectively.
alone or to confi gure the monitor as
Slave when controlling multiple monitors
collectively.