x3
1.5V AA/R6 size
NOT INCLUDED
BATTERIES REQUIRED
Alkaline batteries recommended.Phillips/cross
head screwdriver (not included) needed to
insert batteries.
x2
1.5V AA/R6 size
BATTERIES INCLUDED
Replace with 2 x 1.5V "AA" or LR6 size alkaline
batteries. Phillips/cross head screwdriver (not
included) needed to replace batteries.
x3
1.5V AA/R6 size
BATTERIES INCLUDED
Replace with 3 x 1.5V "AA" or R6 size batteries.
Alkaline batteries recommended. Phillips/cross
head screwdriver (not included) needed to
replace batteries.
CaUtIOn:
1. Be sure to insert the batteries correctly and always follow the
toy and battery manufacturers' instructions.
2. Do not mix old batteries and new batteries or alkaline, standard
(carbon zinc) or rechargeable (nickel-cadmium) batteries.
3. always remove weak or dead batteries from the product.
ImPORtant:
Please retain this information for future reference.
Batteries should be replaced by an adult.
CaUtIOn:
1. always follow the instructions carefully. Use only batteries specified and be sure to insert item correctly by
matching the + and – polarity markings.
2. Do not mix old batteries and new batteries or standard (carbon-zinc) with alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short-circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical interference, move it away from other electrical
equipment. Reset (switching off and back on again or removing and re-inserting batteries) if necessary.
7. ReCHaRGeaBLe BatteRIeS: Do not mix these with any other types of batteries. always remove from the product
before recharging. Recharge batteries under adult supervision. DO nOt ReCHaRGe OtHeR tYPeS OF BatteRIeS.
this equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. these limits are designed to provide reasonable protection against harmful interference
in a residential installation. this equipment generates, uses and can radiate radio frequency energy, and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Consult the dealer or an experienced radio/tV technician for help.
Some poses may require additional support.
Product and colors may vary.
© 2006 Lucasfilm Ltd. & ® or tm where indicated. all rights reserved.
®* and/or tm* & © 2007 Hasbro. all Rights Reserved.
tm & ® denote U.S. trademarks
Package U.S. Patent Pending
*
x2
BATTERIES INCLUDED
Replace with 2 x 1.5V "AA" or R6 size batteries.
Alkaline batteries recommended. Phillips/cross head
screwdriver (not included) needed to insert batteries.
1.5V AA/LR6 size
NOT INCLUDED
Phillips/cross head screwdriver (not
included) needed to insert batteries.
to replace batteries: Using a Phillips/cross head screwdriver
(not included), loosen screw in battery compartment door
(screw remains attached to door). Remove door. Insert 3 x 1.5V
"aa" or R6 size batteries. alkaline batteries recommended.
Replace door and tighten screw.
x2
BATTERIES INCLUDED
BATTERIES INCLUDED
Replace with 2 x 1.5V "A76" or LR44 button cell
batteries. Phillips/cross head screwdriver (not
included) needed to replace batteries.
x2
BATTERIES INCLUDED
BATTERIES INCLUDED
Replace with 2 x 1.5V "AG3" or LR41 button cell
batteries. Phillips/cross head screwdriver (not
included) needed to replace batteries.
x3
BatteRY InFORmatIOn
1.5V AA/LR6 size
NOT INCLUDED
Phillips/cross head screwdriver (not included)
needed to insert batteries.
BATTERIES REQUIRED
Alkaline batteries recommended.
Phillips/cross head screwdriver (not
included) needed to insert batteries.
FCC Statement:
1.5V AA/R6 size
x2
ALKALINE
CANTINA BAND
BATTERIES
REQUIRED
A76/LR44 Alkaline
AG3/LR41 Button Cell
ALKALINE
BATTERIES
REQUIRED
x2
1.5V AAA/R03 size
NOT INCLUDED
x3
1.5V AAA/R03 size
NOT INCLUDED
3
+
AGES
87377/87386 Asst.
Motorized products that do N
D, batteries should declare tha
are required.
x3
1.5V AAA
LR03 size
ALKALINE
BATTERIES
REQUIRED
NOT INCLUDED
Phillips/cross head
screwdriver (not included)
needed to insert batteries.
x3
1.5V AAA/LR03 size
NOT INCLUDED
Phillips/cross head screwdriver (not inc
needed to insert batteries.
x3
1.5V AAA/LR03 size
NOT INCLUDED
Pn: 6688860000
BATTE
Alkaline batt
screwdriver
ALKALIN
BATTERI
REQUIRE
ALKALIN
Phillips/cross
to insert batte
Need help?
Do you have a question about the Star Wars Galactic Heroes Cantina Band 87377 and is the answer not in the manual?
Questions and answers