Advertisement
Quick Links
Helmet:
x3
1.5V AA/R6 size
BATTERIES INCLUDED
Replace with 3 x 1.5V "AA" or R6 size
batteries. Alkaline batteries recommended.
Phillips/cross head screwdriver (not included)
needed to replace batteries.
Light:
x3
1.5V AAA/R03 size
NOT INCLUDED
BATTERIES REQUIRED
Alkaline batteries recommended.
This is not a protective device.
Phillips/cross head screwdriver (not
included) needed to insert batteries.
This is not a protective device.
AGES
CAUTION:
Light is not a flashlight.
CAUTION:
Light is not a flashlight.
IMPORTANT! PLEASE READ INSTRUCTIONS
COMPLETELY BEFORE WEARING TOY.
5
+
87845
1
Adjust straps to fit child's head.
Straps can be readjusted once they
are attached to helmet. To adjust, lift
straps off posts, slide straps to desired
position, and press straps onto posts.
4
Attach crest to
helmet back.
ASSEMBL Y & STRAP ADJUSTMENT
2
2
1
Attach straps to helmet
front: Insert tabs into holes
on inside of helmet and slide
up towards top of helmet.
Make sure all four mounting
points are secure.
5
6
Attach helmet back
Attach light to
to helmet front.
helmet as shown.
3
Attach upper and lower
halves of helmet back.
1
Advertisement
Related Manuals for Hasbro The Clone Wars AEGS 5+
Summary of Contents for Hasbro The Clone Wars AEGS 5+
- Page 1 IMPORTANT! PLEASE READ INSTRUCTIONS Helmet: COMPLETELY BEFORE WEARING TOY. 1.5V AA/R6 size BATTERIES INCLUDED Replace with 3 x 1.5V “AA” or R6 size batteries. Alkaline batteries recommended. Phillips/cross head screwdriver (not included) needed to replace batteries. Light: 1.5V AAA/R03 size NOT INCLUDED BATTERIES REQUIRED Alkaline batteries recommended.
- Page 2 WEARING HELMET Place helmet straight down on head. Make sure the straps are adjusted to keep it steady on the child’s head so your child can see through the eyes. The helmet comes packaged in a “try me” mode. Move switch from “Try Me” position to “On”...
- Page 3 TO REPLACE BATTERIES TO REPLACE HELMET BATTERIES Remove crest section over battery compartment door. Loosen screw in battery compartment door with a Phillips/ cross head screwdriver (not included). Remove door. Remove and discard batteries. Insert 3 x 1.5V “AA” or R6 size batteries.
- Page 4 2. Do not mix old batteries and new batteries, or standard (carbon-zinc) with alkaline batteries. 3. Remove exhausted or dead batteries from the product. 4. Remove batteries if product is not to be played with for a long time. 5. Do not short-circuit the supply terminals. 6. Should this product cause, or be affected by, local electrical interference, move it away from other electrical equipment. Reset (switching off and back on again or removing and re-inserting batteries) if necessary. 7. RECHARGEABLE BATTERIES: Do not mix these with any other types of batteries. Always remove from the product before recharging. Recharge batteries under adult supervision. DO NOT RECHARGE OTHER TYPES OF BATTERIES. 8. As with all small items, these batteries should be kept away from children. If swallowed, seek medical attention immediately. FCC Statement: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Consult the dealer or an experienced radio/TV technician for help. CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Product and colors may vary. © 2008 Lucasfilm Ltd. & ® or TM where indicated. All rights reserved. ®* and/or ™* & © 2008 Hasbro. All Rights Reserved. ™ & ® denote U.S. Trademarks. P/N 6797020000...