Advertisement
Quick Links
FCC Statement:
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy, and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING: Changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to
operate the equipment.
*
Not suitable for children
under 3 years because of
small parts - choking hazard.
Product and colors may vary.
© 2008 Lucasfilm Ltd. & ® or TM where indicated. All rights reserved.
®* and/or TM* & © 2007 Hasbro. All Rights Reserved.
*
TM & ® denote U.S. Trademarks.
Alkaline batteries recommended.
Phillips/cross head screwdriver (not
included) needed to insert batteries.
BATTERIES REQUIRED
Alkaline batteries recommended.
Phillips/cross head screwdriver (not
included) needed to insert batteries.
P/N 6769590000
x3
1.5V AA/R6 size
NOT INCLUDED
6
+
AGES
87625/87623 Asst.
Advertisement
Related Manuals for Hasbro Star Wars Clone Wars Ultimate Lightsaber 87623
Summary of Contents for Hasbro Star Wars Clone Wars Ultimate Lightsaber 87623
- Page 1 - choking hazard. Product and colors may vary. © 2008 Lucasfilm Ltd. & ® or TM where indicated. All rights reserved. ®* and/or TM* & © 2007 Hasbro. All Rights Reserved. TM & ® denote U.S. Trademarks. Phillips/cross head screwdriver (not included) needed to insert batteries.
- Page 2 PARTS Hilt Blade End caps Tonfa handle Kyber crystals (3) Blade-emitter guard Hilt sleeves (4) Sleeve rings (3) STEP 1 The first step in building a lightsaber is to install the power-generating component. INSTALLING BATTERIES Using a Phillips/crosshead screwdriver (not included), loosen screw in door and remove door.
- Page 3 CAUTION: TO AVOID BATTERY LEAKAGE 1. Be sure to insert the batteries correctly and always follow the toy and battery manufacturers’ instructions; 2. Do not mix old and new batteries or alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries; 3. Always remove weak or dead batteries from the product. IMPORTANT: BATTERY INFORMATION Please retain this information for future reference.
- Page 4 STEP 3 Place blade on hilt and hold it in place. HILT BLADE STEP 4 Choose a sleeve ring and slide it over the blade. SLEEVE RING STEP 5 Choose a hilt sleeve and slide it on the hilt. SLEEVE NOTE: Line up rib inside sleeve with slot on hilt.
- Page 5 ASSEMBLING CHARACTER-SPECIFIC LIGHTSABERS Green Blue Green...