x2
1.5V AA/R6 size
BATTERIES INCLUDED
Replace with 2 x 1.5V "AA" or R6 size batteries.
Alkaline batteries recommended. Phillips/cross head
screwdriver (not included) needed to insert batteries.
x2
ALKALINE
BATTERIES
1.5V AA/LR6 size
REQUIRED
NOT INCLUDED
Phillips/cross head screwdriver (not included)
needed to insert batteries.
To install batteries:
1. Using a Phillips/cross head
screwdriver (not included),
x2
unscrew battery cover.
A76/LR44 Alkaline
BATTERIES INCLUDED
BATTERIES INCLUDED
2. Insert 2 fresh 1.5 V "AA"
or LR6 batteries. See diagram
Replace with 2 x 1.5V "A76" or LR44 button cell
batteries. Phillips/cross head screwdriver (not
for polarity.
included) needed to replace batteries.
3. Replace battery cover and
tighten screw.
CAUTION:
TO AVOID BATTERY LEAKAGE
1. Be sure to insert the batteries correctly and always follow the toy and
battery manufacturers' instructions;
2. Do not mix old and new batteries or alkaline, standard (carbon-zinc)
or rechargeable (nickel-cadmium) batteries;
3. Always remove weak or dead batteries from the product.
Not suitable for children
under 3 years because of
small parts, choking hazard.
®
*
x3
BATTERIES REQUIRED
Alkaline batteries recommended. Phillips/cross head
1.5V AAA/R03 size
IMPORTANT:
screwdriver (not included) needed to insert batteries.
BATTERY INFORMATION
NOT INCLUDED
Please retain this information for future reference. Batteries should be replaced by an adult.
Class 1 LED product.
TM
Motorized products that do NOT include but require AAA, AA, C,
1. Always follow the instructions carefully. Use only batteries specified and be sure
D, batteries should declare that alkaline ("LR") type batteries
to insert item correctly by matching the + and – polarity markings.
Bump & Go Chopper
are required.
2. Do not mix old batteries and new batteries or standard (carbon-zinc) with alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
x3
1.5V AAA
5. Do not short circuit the supply terminals.
LR03 size
6. Should this product cause, or be affected by, local electrical interference, move
ALKALINE
it away from other electrical equipment. Reset (switching off and back on again or
BATTERIES
removing and re-inserting batteries) if necessary.
REQUIRED
7. RECHARGEABLE BATTERIES: Do not mix these with any other types of battery.
Always remove from the product before recharging. Recharge batteries under adult
NOT INCLUDED
supervision. DO NOT RECHARGE OTHER TYPES OF BATTERIES.
Phillips/cross head
screwdriver (not included)
needed to insert batteries.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
x3
ALKALINE
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
BATTERIES
provide reasonable protection against harmful interference in a residential installation.
1.5V AAA/LR03 size
REQUIRED
This equipment generates, uses and can radiate radio frequency energy, and, if not
NOT INCLUDED
installed and used in accordance with the instructions, may cause harmful interference
Phillips/cross head screwdriver (not included)
to radio communications. However, there is no guarantee that interference will not
needed to insert batteries.
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
x3
•
ALKALINE BATTERIES REQUIRED
•
Phillips/cross head screwdriver (not included) needed
1.5V AAA/LR03 size
•
to insert batteries.
NOT INCLUDED
Product and colors may vary.
Spider-Man and all related characters: TM & © 2006 Marvel Characters, Inc. Spider-Man movie elements:
© 2002-2006 Columbia Pictures Industries, Inc. All rights reserved. Licensed by Spider-Man Merchandising L.P.
®* and/or TM* & © 2006 Hasbro. All Rights Reserved.
TM & ® denote U.S. Trademarks.
Hasbro Canada, Longueuil, QC, Canada J4G 1G2
CAUTION:
x3
1.5V AAA
LR03 size
ALKALINE
BATTERIES
REQUIRED
FCC STATEMENT
NOT INCLUDED
Phillips/cross head
screwdriver
(not included)
needed to insert
batteries.
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Consult the dealer or an experienced radio/TV technician for help.
x3
BATTERIES
Replace with 3 x 1.5V "AAA" o
1.5V AAA/R03 size
Alkaline batteries recommend
3+
screwdriver (not included) nee
AGES
79040/79037 Asst.
Motorized products that include AAA, AA,
declare that batteries are included and rep
batteries is required.
x3
BATTERIES
INCLUDED
Replace with 3 x 1.5V "AAA"
or LR03 size alkaline batteries .
Phillips/cross head screwdriver
(not included) needed to insert
batteries.
x3
BATTERIES INCLUDED
Replace with 3 x 1.5V "AAA" or LR0.3 size alkaline
batteries . Phillips/cross head screwdriver (not included)
needed to insert batteries.
x3
BATTERIES
Replace with 3 x 1.5V "AAA" or LR03 size alkaline batteries . P
(not included) needed to insert batteries.
x4
P/N: 6613440000
BATTERIES
Need help?
Do you have a question about the Spiderman Origins Bump and Go Chopper 79037 and is the answer not in the manual?
Questions and answers