Hasbro 79057/79037 Instructions

ALKALINE
x2
BATTERIES
1.5V AA/LR6 size
REQUIRED
NOT INCLUDED
Phillips/cross head screwdriver (not included)
needed to insert batteries.

To install batteries:

1. Using a Phillips/cross head
screwdriver (not included),
unscrew battery cover.
2. Insert 2 fresh 1.5 V "AA"
or LR6 batteries. See diagram
for polarity.
3. Replace battery cover and
tighten screw.
CAUTION:
TO AVOID BATTERY LEAKAGE
1. Be sure to insert the batteries correctly and always follow the toy and
battery manufacturers' instructions;
2. Do not mix old and new batteries or alkaline, standard (carbon-zinc)
or rechargeable (nickel-cadmium) batteries;
3. Always remove weak or dead batteries from the product.
Not suitable for children
under 3 years because of
small parts, choking hazard.
®
*
IMPORTANT:
Please retain this information for future reference. Batteries should be replaced by an adult.
TM
Bump & Go
Spider-Man®
ATV 4-Wheeler
BATTERY INFORMATION
Class 1 LED product.
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified and be sure
to insert item correctly by matching the + and – polarity markings.
2. Do not mix old batteries and new batteries or standard (carbon-zinc) with alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical interference, move
it away from other electrical equipment. Reset (switching off and back on again or
removing and re-inserting batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other types of battery.
Always remove from the product before recharging. Recharge batteries under adult
supervision. DO NOT RECHARGE OTHER TYPES OF BATTERIES.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy, and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Product and colors may vary.
Spider-Man and all related characters: TM & © 2006 Marvel Characters, Inc. Spider-Man movie elements:
© 2002-2006 Columbia Pictures Industries, Inc. All rights reserved. Licensed by Spider-Man Merchandising L.P.
®* and/or TM* & © 2006 Hasbro. All Rights Reserved.
TM & ® denote U.S. Trademarks.
Hasbro Canada, Longueuil, QC, Canada J4G 1G2
79057/79037 Asst.

FCC STATEMENT

3+
AGES
P/N: 6605230000