Electrical Connections; Permanent Connection - Zanussi FLS 702 Instruction Booklet

Electrical connections

The applicable rules for electrical security
require an adequate earthing. The plug of the
appliance is provided with such a device.
Make sure your socket outlet is provided with an
adequate earthing too.
The manufacturer declines any liability in case of
accidents or incidents should these safety measures
not be observed.
Before plugging the appliance make sure that:
The mains of your installation is the same as on the
rating plate of your appliance (the plate is sticked to
the rear of the appliance).
The meter, the fuses, the wiring and the socket outlet
can support the max. power absorbed stated on the
rating plate.
The socket base and the plug must fit in adequately
without any reducing interposition, multiple outlets
or adapters. If necessary replace the socket outlet by
an adequate one.
Should the plug need to be replaced for any reason,
you must connect the green and yellow (earth) wire
to the terminal in the plug which is marked with the
letter «E» or the earth symbol
and yellow.

Permanent connection

In the case of permanent connection it is necessary that
you install a double pole switch between the appliance
and the electricity supply (mains), with a minimum gap
of 3 mm between the switch contacts and of a type
suitable for the required load in compliance with the
current electrical regulations.
The switch must not break the yellow and green earth
cable at any point.
or coloured green
20