Table of Contents
Advertisement
35.292.652/0
WASHING MACHINE
FLS 702
FLS 802
BOMULD OG LINNED
1
30º-90º
KOGEVASK MED FORVASK
2
30º-90º
KOGEVASK UDEN FORVASK
2
30º-60º
KULØRTVASK
3
30º-40º
KULØRTVASK
4
SKYLNINGER
5
SKYLLEMIDDEL
6
CENTRIFUGERING
INSTRUCTION BOOKLET
ИНСТРУКЦИЯ ПО ЭКСПЛУАТАЦИИ
F L S -
SYNTETISK VASK, FINVASK OG
7
30º-60º
SYNTETISK VASK MED FORVASK
8
30º-60º
SYNTETISK VASK UDEN FORVASK
9
30º-40º
FINVASK ULD SKYLNINGER
1
40º
SKILLEMIDDEL
0
TØMNING
1
1
Advertisement
Table of Contents
Related Manuals for Zanussi FLS 702
Summary of Contents for Zanussi FLS 702
-
Page 1: Washing Machine
WASHING MACHINE FLS 702 FLS 802 F L S - BOMULD OG LINNED SYNTETISK VASK, FINVASK OG 30º-90º KOGEVASK MED FORVASK 30º-60º SYNTETISK VASK MED FORVASK 30º-90º KOGEVASK UDEN FORVASK 30º-60º SYNTETISK VASK UDEN FORVASK 30º-60º KULØRTVASK 30º-40º FINVASK ULD SKYLNINGER 30º-40º... -
Page 2: Important Safety Information
Under no circumstances should you attempt to repair the machine yourself. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. Contact your local Zanussi Service Centre. Always insist on genuine Zanussi spare parts. -
Page 3: Table Of Contents
Table of Contents For the User For the Installer Important Safety Information Installation Instructions Description of the Appliance Technical Specifications The Control Panel Installation Unpacking Operating sequence Water inlet Before the first use Water drainage 18-19 Load the laundry Levelling Measure out the detergent Special conditions Measure out the additives... -
Page 4: Description Of The Appliance
Description of the Appliance 1 Detergent dispenser drawer 2 “Mains-on” light 3 “Options” buttons 4 Temperature selector dial 5 Program selector dial & ON/OFF switch 6 Door opening handle 7 Filter 8 Adjustable feet Detergent dispenser drawer <<prewash>> symbol shows the compartment for the prewash detergent. -
Page 5: The Control Panel
On the program chart you will find the most appropriate temperature for each kind of washing. Pressing this button the spinning speed is reduced from 700 to 400 rpm (model FLS 702) and from 800 to 400 rpm (model FLS 802). 6 PROGRAM SELECTOR... -
Page 6: Operating Sequence
Operating Sequence Before your first wash, we recommend that you run a cotton cycle at 60°C, without any laundry in the machine, to remove any manufacturing residue from the drum and tub. Pour 1/2 a measure of detergent into the dispenser drawer and start the machine. -
Page 7: Select The Temperature
5. Select the temperature Turn the dial to the desired temperature. P0345 6. Select the required programme Turn the programme selector dial CLOCKWISE to the required programme. P0215 7. Start the machine Before starting up the machine check that: the appliance is plugged in the water supply tap is turned on the door and the detergent dispenser drawer are closed. -
Page 8: Washing Programmes
Spin Spin at 700 rpm (FLS702) Spin at 800 rpm (FLS802) (•) This 60°C programme is the reference programme for the Energy label according to EEC Directive 92/75. (Load 4,5 Kg.) FLS 702 FLS 802 Water 72 litres 72 litres... - Page 9 Washing Programmes Programmes for synthetics, delicates and wool Maximum load 2 kg (wool maximum load 1 kg) Program Compartments Possible dial Program Temperature ˚C Degree of soil Description to use options position Prewash at 40 ˚C Mixed Wash at 40˚- 60˚C 40°- 60°...
-
Page 10: Washing Hints
Washing Hints Sorting the laundry Laundry weights Follow the wash code symbols on each garment label The following weights are indicative: and the manufacturer’s washing instructions. Bathrobe 1200 g Sort the laundry as follows: Napkin 100 g whites, coloureds, synthetics, delicates, woollens. Quilt cover 700 g Sheet... -
Page 11: Quantity Of Detergent To Be Used
Lipstick: moisten with acetone as above, then treat Quantity of detergent to be used stains with methylated spirits. Remove any residual The type and quantity of detergent will depend on the marks from white fabrics with bleach. type of fabric, load size, degree of soiling and hardness Red wine: soak in water and detergent, rinse and treat of the water used. -
Page 12: International Wash Code Symbols
International wash code symbols These symbols appear on fabric labels, in order to help you choose the best way to treat your laundry. ENERGETIC WASH Max. wash Max. wash Max. wash Max. wash temperature temperature temperature temperature 95°C 60°C 40°C 30°C Hand wash Do not wash... -
Page 13: Maintenance
Maintenance Before any maintenance or cleaning is carried out you must DISCONNECT the appliance from the electricity supply. 1. Bodywork Clean the outside of the machine with warm water and a neutral, non-abrasive household detergent. Rinse with clean water and dry with a soft cloth. Important: do not use methylated spirits, solvents or similar products to clean the bodywork. -
Page 14: Drain Filter
4. Drain filter The drain filter collects threads and small objects inadvertently left in the laundry. Check regularly that the filter is clean. Open the filter door. Place a container under the filter and unscrew it. AL015 AL012 Pull out the filter. Clean the filter under a running tap, then refit it, screwing it fully in. -
Page 15: Something Not Working
Something Not Working Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your Local service Force Centre, please carry out the checks listed below. Symptom Possible causes Check that the door is firmly closed. -
Page 16: Installation Instructions
Delicate fabrics 2 kg Wool 1 kg SPIN SPEED Maximum FLS 702 700 rpm FLS 802 800 rpm This appliance complies with the following E.E.C. Directives: - 73/23 EEC of 19.2.73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3.5.89 (Electromagnetic Compatibility Directive) and subsequent modifications. -
Page 17: Installation
Installation Unpacking You are advised to keep all the packaging for re-use in case the appliance has to be transported again. Before starting the machine up, the transport security bolts must be removed as follows. Unscrew and remove the three rear transit bolts (using a spanner). -
Page 18: Water Inlet
Water inlet There should be a COLD WATER tap near the washing machine with a screwing on connection pipe of 3/4 gas for the water supply, a sink, a wash basin or a drainage system in the wall. Previously check if: it is not a hot water tap the running water is clean. -
Page 19: Levelling
Whether discharging into a sink or a standpipe check that the end of the drain hose is neither too high nor too low. The top of the curve in the hose’s end should be no more than 90 cm, and no less than 60 cm above floor level. Should a prolongation of the drain hose be unavoidable this must never surpass 1.5 m and must be of the same diameter as the original hose... -
Page 20: Electrical Connections
Electrical connections The applicable rules for electrical security require an adequate earthing. The plug of the appliance is provided with such a device. Make sure your socket outlet is provided with an adequate earthing too. The manufacturer declines any liability in case of accidents or incidents should these safety measures not be observed.