Table of Contents
Advertisement
Door reversal
The applianceÕs door has been locked in position for
transport by means of pins on both sides. According
to the door opening direction, remove relevant pins
at the top and at the bottom.
A
B
D163
Building-in
Dimensions of the recess
Height of housing (1)
Depth of housing (2)
Width of housing (3)
PR0
It is necessary that the niche is provided with a
conduct of ventilation having the following
dimensions:
Depth
50 mm
Width
540 mm
702
mm
550 mm
560 mm
3
1
2
Warning!
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to the
cabinet. In that case, wait for the natural fitting
of the gasket or accelerate this process by
heating up the part involved with a normal
hairdrier.
To ensure adequate ventilation, follow the
instructions in the figure.
560 min
2
min 200cm
D474
The appliance door must be about 20 mm lower than
the worktop.
1. Push the appliance into the recess, making sure
that it is set back 7 mm from the edge of the base
recess.
D475
600
550 min
50
20
9
Advertisement
Table of Contents
