Door Reversibility - Zanussi ZD 19/5 R Instruction Booklet

Door reversibility

Unplug the refrigerator from the wall socket before
performing the following operations:
Remove the lower hinge (1) and the support foot (2).
Unscrew the front left support foot (3) and screw it
into the corresponding position on the opposite side.
Unscrew the two screws which hide the fixing holes
of the hinge on the left-hand side.
Detach the lower door from the central hinge (H).
Remove the central hinge and detach the upper
door from the pin (5). Unscrew the pin (5) and screw
it into the corresponding position on the opposite
side.
Remove the two plugs, to reveal the holes for the
hinge pivots, and remount them on the other side.
Re-assemble the lower hinge (1) and the support
foot (2) on the opposite side.
Attention
After completion of the door reversibility operation,
verify that the door gasket is adherent to the
cabinet. If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to the
cabinet. In that case, wait for the natural fitting of
the gasket or accelerate this process by heating up
the part involved with a normal hairdrier.
D548
H
D405
D419
3
D715
Fig. 3
5
Fig. 4
Fig. 5
Fig. 6
1
2
37