Page 2
This appliance has been designed for refrigeration or freezing purposes, and can be operated on both A.C. and D.C. power supplies. The internal power supply will automatically switch from DC to AC power, and back. MODEL NO. ………………….. SERIAL NO. …………………….. The model and serial number may be found on the compressor cover on the side of the unit.
INSTALLING HANDLES Lifting handles are furnished with larger models (MT17F-U1, MT27F-U1, MT35F-U1, MT45F-U1, MT60F-U1, MT60F-U1-C, MT80F-U1), and are packed loose inside the refrigerator. They are to be installed using the screws and tapped holes provided. CONNECTING TO POWER SOURCE 120 VOLTS A.C. OPERATION IN YOUR HOME; Your refrigerator needs so little power that it may be connected to any A.C.
Page 4
IMPORTANT: NEVER USE WIRING LESS THAN AWG # 12 BETWEEN THE BATTERY AND REFRIGERATOR. INSTALL A 10 AMP FUSE IN THE POWER SUPPLY CIRCUIT. BE SURE THE POWER SUPPLY POLARITY IS CORRECT. In the event that the green refrigerator light fails to glow inspect the power source for proper voltage and correct polarity.
OPERATION To start your refrigerator, set the thermostat control knob to "ON". Your refrigerator should start operating. The interior should start getting cool to touch within a few minutes. PROTECTION SYSTEM The D.C. power cord is made for negative (-) ground system. Your refrigerator has a high current protection system incorporated in the electronic circuit to prevent damage to its power supply, which may occur due to a reverse connection.
CAUTION: Never use a brush, powder soap, cleanser, acid, benzene, gasoline, or mineral thinners. These tend to leave scratches on the plastic coating. For more information contact Engel USA on Tel: 888-272-9838 www.engel-usa.com SAWAFUJI ELECTRIC CO., LTD. TOKYO JAPAN (Cat. No. 5490 298 1000) Printed in USA...