Door Reversibility - Zanussi ZFC 170 Instruction Booklet

Door reversibility

Unplug the appliance before performing the following
operations:
Carefully lay the appliance on its back.
Remove the foot (A-Fig. 3).
Remove the hinge (C) by unscrewing the screws
(B).
Remove the stop catch (E) by unscrewing the
screws (D).
Slide the door out of the upper hinge.
Remove the upper hinge and fit on the opposite side
(Fig. 4).
Reassemble the door, inserting the upper hinge pin
into the bushing on the door.
Unscrew the left foor and refit on the opposite side.
Fit the stop catch (E) on the opposite side.
Fit the hinge (C) and foot (A) on the opposite side.
Change the position of the handle (Fig. 5).
The holes that are not used are to be masked with
the plastic plugs removed.
Attention
After completion of the door reversibility operation,
verify that the door gasket is adherent to the
cabinet. If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to the
cabinet. In that case, wait for the natural fitting of
the gasket or accelerate this process by heating up
the part involved with a normal hairdrier.
E
C
D
B
D473
D185
D162
Fig. 3
A
Fig. 4
Fig. 5
5