WARNINGS It is most important that this instruction book should be should solid ice be forced off the liner. Solid ice retained with the appliance for future reference. Should should be allowed to thaw when defrosting the the appliance be sold or transferred to another owner, or appliance.
INSTALLATION If this appliance featuring magnetic door seals is to Electrical connection replace an older appliance having a spring lock (latch) on Before plugging in, ensure that the voltage and the door or lid, be sure to make that spring lock frequency shown on the serial number plate unusable before you discard the old appliance.
Changing the opening direction of the door Fig. 2 Unplug the freezer before performing the following operations: Remove the ventilation grid (C). Unscrew the bottom hinge (D). Remove the door from the upper pivot (A). Remove the pivot from the upper hinge (B), then mount it on the opposite side.
Aligning the worktop of the appliance with the Important kitchen furniture For the appliance to function properly, an opening of at least 137 cm (Fig. 8) must be cut in the The appliance worktop is aligned with the door. kitchen worktop. It can however be easily aligned to the kitchen furniture by proceeding as follows: A minimum clearance must also be provided...
Operation provided. Butter and cheese: these should be placed in special Insert the plug into the wall socket. airtight containers or wrapped in aluminium foil or Open the refrigerator door and turn the thermostat polythene bags to exclude as much air as possible. knob, clockwise, beyond the «O»...
Thawing Movable shelves (Only for model ZFC 1503 S) Fig. 10 Deep-frozen or frozen food, prior to being used, can The walls of the be thawed in the refrigerator compartment or at refrigerator are room temperature, depending on the time available equipped with a for this operation.
Defrosting (Only for model ZFC 1503 S) The freezer compartment, however, will become Frost is automatically eliminated from the progressively covered with frost. This should be evaporator of the refrigerator compartment every removed with the special plastic scraper provided, time the motor compressor stops, during normal whenever the thickness of the frost exceeds 4 mm.
MAINTENANCE Unplug the appliance before carrying out any Interior light maintenance operation. The light bulb inside the refrigerator compartment can be reached as follows: Warning unscrew the light cover securing screws; This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore unhook the moving part by pressing it as shown only be carried out by authorized technicians.