Door Reversibility - Zanussi ZFC 15/4 RD Instruction Booklet

Door reversibility

Before carrying out the operations described below,
pull out the mains plug from the wall socket.
To carry out door reversal operate as follows:
Remove the plastic cover (6) (which has a clip-in
fitting) masking the bottom hinge;
Remove bottom hinge (1);
Slide out the lower door from middle hinge (2) and
remove the latter;
Slide out the upper door from pin (3), unscrew the
latter and then screw it down into the hinge
provided on the opposite side;
Remove the two plugs, to reveal the holes for the
hinge pivots, and remount them on the other side;
Refit the upper door and the middle hinge on the
opposite side;
Refit the lower door and bottom hinge (1) on the
opposite side, after having removed the plugs (7)
and screws; these must then be refitted in the holes
on the opposite side;
Refit the plastic cover (6) on the bottom hinge.
Warning:
After having reversed the opening direction of the doors
check that all the screws are properly tightened and that
the magnetic seal adheres to the cabinet. If the ambient
temperature is cold (i.e. in Winter), the gasket may
not fit perfectly to the cabinet. In that case, wait for
the natural fitting of the gasket or accelerate this
process by heating up the part involved with a
normal hairdrier.
34
D668
3
2
1
7
6