Invacare   Storm Arrow Service Manual page 64

CAUTION
DO NOT over tighten the mounting screws that
secure the actuator to the pivot block. Damage
to the actuator will occur.
FIGURE 2 - ADJUSTING LIMIT SWITCH
REPLACING RECLINER CABLE
ASSEMBLIES (FIGURE 3)
WARNING
Replace ONE (1) recliner cable assembly at a
time to avoid injury.
DO NOT force the gas cylinder rod into the op-
erator of the recliner cable assembly.
POSITION OVER
DO NOT cross thread the operator of the recliner
O
105 RELATIVE TO
cable assembly with the gas cylinder.
THE SEAT FRAME
If slack in the recliner cable or movement in the
operator of the cable assembly can not be elimi-
nated, DO NOT use the recliner cable assembly.
FIGURE 3 - REPLACING RECLINER CABLE ASSEMBLIES
CAUTION