Zanussi ZAF20 Instructions For Use Manual page 6

REPLACEMENT OF THE VOLTAGE CABLE
The connection of the voltage cable to the appliance's terminal box is of type "Y" which signifies that its
replacement requires the specific equipment of a technician. If the replacement of the cable is necessary, use
only cables type H 05 VV H2-F O T 105; in both cases, the cables must be of sections suitable to the voltage
and able to support the working heat. Furthermore it is necessary that the yellow/green earth wire be
approximately 2 cm longer than the phase wires (fig.3). After connection try out the heating elements by
allowing them to function for about three minutes.
Earth wire (yellow - green)
FO 0073
To open the terminal box and reach the terminals
proceed as described below:
- insert the point of a screwdriver into the visible
protruding part of the terminal box;
- exert a light pressure and lift (fig. 4).
Neutral
Fig. 3
The manufacturer declines all responsibility if
the accident prevention regulations are not
respected.
This appliance conforms to Directive EEC N. 87/
308 of 2.6.87 relating to the abolition of radio
interference.
FO 0287
Fig. 4
35