Table of Contents
Advertisement
USE
Cleaning the interior
Before using the appliance for the first time, wash
the interior and all internal accessories with luke-
warm water and some neutral soap so as to remove
the typical smell of a brand-new product, then dry
thoroughly.
Control panel
0
6
5
1
4
2
3
A
A. Thermostat knob (freezer)
B. Super (quick-freezing) switch
C. SUPER operating control light
D. Warning light
E. Pilot light (freezer)
USE OF THE REFRIGERATOR
Operation
The temperature inside the refrigerator compartment
can be selected using thermostat (I).
Temperature regulation
The temperature is automatically regulated and can
be increased to achieve a higher temperature
(warmer) by rotating the thermostat knob toward
lower settings or reduced (colder) rotating the knob
towards higher settings.
However, the exact setting should be chosen
keeping in mind that the temperature inside the
refrigerator depends on:
room temperature;
how often the door is opened;
the quantity of food stored;
location of appliance.
A medium setting is generally the most suitable.
To stop operation, simply turn the thermostat knob to
position ÇOÈ.
54
B
C D E
F. DAC knob
G. Pilot light DAC
H. Pilot light (refrigerator)
I. Thermostat knob (refrigerator)
Important
If the ambient temperature is high or the
appliance is fully loaded, and the appliance is
set to the lowest temperatures, it may run
continuously causing frost to form on the rear
wall. In this case the dial must be set to a higher
temperature to allow automatic defrosting and
therefore reduced energy consumption.
Air circulation
Inside the appliance, there is a fan (DAC) which is
turned on by means of the switch (F). The pilot light
(G) will light up.
It is recommended that the fan be used when the
ambient temperature is above 25 ¡C with the knob
set to the position identified by the symbol.
At ambient temperatures up to 25 ¡C, the fan may
be used with the knob set to any position.
However, for lower energy consumption, leave the
DAC fan turned off at ambient temperatures below
25 ¡C.
Do not use detergents or abrasive
powders, as these will damage the finish.
F
G
0
6
1
5
2
4
3
H
I
Advertisement
Table of Contents
