Cisco UCS C220 M3 Installation And Service Manual page 66

Installing or Replacing Server Components
Press the top button on the tool to release the old CPU on an anti-static surface.
d.
Figure 3-15
Arrow on tool
1
Insert the new CPU into the Pick-and-Place tool:
Step 4
Remove the new CPU from the packaging and place it on the pedestal that is included in the kit.
a.
Align the registration mark on the corner of the CPU with the arrow on the corner of the pedestal
(see
Press down on the top button of the tool to lock it open.
b.
Set the Pick-and-Place tool on the CPU pedestal, aligning the arrow on the tool with the arrow on
c.
the corner of the pedestal. Make sure that the tabs on the tool are fully seated in the slots on the
pedestal.
Press the side lever on the tool to grasp and lock in the CPU.
d.
Lift the tool and CPU straight up off the pedestal.
e.
Cisco UCS C220 Server Installation and Service Guide
3-26
Removing or Inserting a CPU
Figure 3-16).
Chapter 3
1
2
Registration mark on CPU socket
2
Maintaining the Server
OL-25760-01