Table of Contents
Advertisement
5. Water inlet filter
If you notice that the machine is taking longer to fill,
check that the filter in the water inlet hose is not
blocked.
Turn off the water tap.
Unscrew the hose from the tap.
Clean the filter with a stiff brush.
Screw the hose back onto the tap.
6. Emergency emptying out
If the machine is unable to drain, proceed as follows
to empty out the machine:
•
Pull out the plug from the power socket.
•
Close the water tap.
•
If necessary, wait until the water has cooled
down.
•
Place a bowl on the floor under the filter.
•
Slightly loosen the filter to let the water come out
slowly.
•
Clean the filter if necessary.
•
At the end screw the filter again.
7. The dangers of freezing
If the machine is exposed to temperatures below
0°C, certain precautions should be taken.
•
Turn off the water tap.
•
Unscrew the inlet hose.
•
Unhook the drain hose from the rear support and
position the end of this hose and that of the inlet
hose in a bowl. Run the draining programme.
To do this:
• Switch the machine on
• Select a washing programme
• Press the RESET button
• Press START/PAUSE button
•
Disconnect the appliance.
•
Screw the inlet hose and reposition the drain
hose.
•
When you intend to start the machine up again,
make sure that the room temperature is above
0°C.
three times
21
Advertisement
Table of Contents
