Something Not Working; Service Centres - Zanussi FE 1405 Instruction Booklet

Washing machine fe 1405
Table of Contents

Advertisement

Something not working?

Problems which you can resolve yourself.
During machine operation it is possible that the light of the START/PAUSE button
lights start to flash:
: problem with the water supply
: problem with water draining
: door open
At the same time the buzzer sounds.
Once the problem has been eliminated, press the START/PAUSE button
all checks, the problem persists, contact your local Service Centre.
Problem
The machine does not start up:
The machine does not fill:
The machine fills then empties
immediately:
The machine does not empty and/or
does not spin:
There is water on the floor:
Unsatisfactory washing results:
The machine vibrates or is noisy:
to restart the programme. If after
Possible cause
• The door is not firmly closed.
• The machine is not plugged in or there is no power
at the socket.
• The main fuse has blown.
• The START/PAUSE button
depressed.
• The water tap is closed.
• The inlet hose is squashed or kinked.
• The filter in the inlet hose is blocked.
• The door is not properly closed.
• The end of the drain hose is too low. Refer to
relevant paragraph in "water drainage" section.
• The drain hose is squashed or kinked.
• The RINSE HOLD option
• The drain pump is clogged.
• Too much detergent or unsuitable detergent
(creates too much foam) has been used.
• Check whether there are any leaks from one of the
inlet hose fittings. It is not always easy to see this
as the water runs down the hose; check to see if it
is damp.
• The drain hose is damaged.
• The cover of the drain pump has not been
correctly screwed in after cleaning.
• The cap on the emergency emptying hose has not
been replaced after cleaning the pump.
• Too little detergent or unsuitable detergent has
been used.
• Stubborn stains have not been treated prior to
washing.
• The correct temperature was not selected.
• Excessive laundry load.
• The transit bolts and packing have not been
removed.
• The support feet have not been adjusted.
• The laundry is not evenly distributed in the drum.
• Maybe there is very little laundry in the drum.
• The machine is in contact with the wall or
furniture.
39
and one of the following
has not been
has been selected.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents