Zanussi FE1005 Instruction Booklet page 16

132988070gb.qxd 01/06/2004
7. Select the spin speed
HOLD option
Press the SPIN SPEED button
order to select the desired spin speed or the RINSE
HOLD option . The relevant light will light up.
If you select the RINSE HOLD option, the machine
will stop at the end of the programme with the water
still in the tub.
8. Select the desired options
Depress the relevant buttons to select the required
options.
9. Select the DELAY TIME
Before you start the programme, if you wish the
starting to be delayed, press the DELAY button (11)
repeatedly, or keep it pressed, to select the desired
delay. The selected delay time value (up to 23 hours)
will appear on the display for 3 seconds, then the
duration of the programme will appear again.
10. Start the programme
17.41 Pagina 16
or the RINSE
repeatedly, in
10. Start the programme
Press the START/PAUSE button
light will stop flashing and only the light relevant to
the phase that is in progress will remain lit.
If you have chosen a delayed start, the washing
machine will begin the countdown.
The display will show the duration of the programme
or the selected delay.
11. How to change a programme
during its cycle
Before you make any change, you must pause the
washing machine by pressing the START/PAUSE
button.
It is possible to change any phase before the
programme carries it out.
Changing the type of fabric or temperature is
possible, obviously, only during the washing phase.
If it is necessary to drain the water in order to change
the programme in progress, proceed as follows:
• PAUSE the machine by pressing the
START/PAUSE button;
• press the SKIP/RESET button repeatedly, until
only the DRAIN light remains lit;
• press the START/PAUSE button again.
When the water has been drained, the display shows
a blinking zero. You may now select a new
programme and press the START/PAUSE button to
start it.
12. How to cancel a programme
during its cycle
To cancel a programme that is being carried out, first
pause the washing machine by pressing the
START/PAUSE button, then press the SKIP/RESET
button repeatedly, until the display shows three
blinking dashes.
16
. The relevant