Zanussi FE1005 Instruction Booklet page 11

132988070gb.qxd 01/06/2004
This button allows you also to select special
programmes, such as RINSES, SPIN and DRAIN.
• If the machine is already switched on because it
has just performed a washing programme, proceed
as follows:
- depress RESET once or repeatidly to cancel the
previously performed programme (three blinking
dashes will appear on the display);
- select the type of fabric by means of the relevant
button;
- select the special programme:
• RINSES
Depress RESET once, the pilot light WASH
goes out.
• SPIN
Depress RESET twice, the pilot lights WASH
and RINSES
• DRAIN
Depress RESET three times, the pilot lights
WASH , RINSES
Example:
• If the machine is switched off:
- depress ON/OFF button to switch it on;
- select the type of fabric by means of button
select the special programme as previously
described.
11 DELAY button
This button makes it possible to delay the starting of
the programme from 30 min-60 min-90 min, 2 hours
and then by 1 hour up to maximum of 23 hours. The
delay you have selected is shown on the display for
17.40 Pagina 11
In this case, the spin (at
the speed provided for
the selected type of
fabric) will be
performed.
go out.
and SPIN go out.
In this case the
machine will perform
the rinses and spin.
;
about 3 seconds; afterwards, the duration of the
programme reappears.
You must select this option after you have set the
programme and before you press the
START/PAUSE button.
The time value shown on the display will decrease
by one unit every hour.
You can change the delay time at any moment,
before you press the START/PAUSE button.
If you have already pressed the START/PAUSE
button, and you wish to cancel the delay time,
proceed as follows:
• set the washing machine to PAUSE by pressing the
START/PAUSE button;
• press the DELAY button twice, to erase the delay
time. The display will indicate "O O ' ' "
• press the START/PAUSE button again.
Important!
The door will be locked throughout the delay time.
If you need to open the door, you must first set the
washing machine to PAUSE by pressing the
START/PAUSE button. After you have closed the
door, press the START/PAUSE button again.
12 Programme phase indicator
lights
When you select a programme, the lights relevant to
the phases that form the programme light up.
After you have started the programme, only the light
relevant to the phase that is currently being carried
out will remain lit.
11