Using The Appliance; Starting A Wash Programme - Zanussi FCS 725C Instruction And Installation Book

Using the appliance

Have you removed all the transit locking devices?
The very first time the machine is used, you should
run a wash programme without any load, to clear any
residues which may have been left by the manufac-
turing process. Pour approx. 100 ml of detergent
straight into the drum and run a programme at 60°C.
When the programme is finished, the machine will be
ready for use.

Starting a wash programme

Before starting up the machine, check that:
the door is properly closed
G
the appliance is plugged in
G
the water supply tap is turned on
G
To start the machine, proceed as follows:
1. Pull the door latch gently to open the door.
2. Fill the drum evenly with the laundry. Large and
small items can be mixed.
Always try to wash full loads: for maximum load
weights see the programme charts. You should
only reduce the load weight for heavily soiled items
and sensitive materials.
3. Close the door.
4. Pull out the dispenser drawer.
5. Measure out the amount of detergent required and
pour it into the larger compartment on the left (fig 1).
6. Pour fabric softener into the smaller compartment
on the right without exceeding the max. level (fig. 2).
7. Close the drawer.
8. Select the required programme (fig. 3).
9. Turn the spin speed selector to the required
position (fig. 4).
10. Select the required option. The corresponding
light illuminates (fig. 5).
11. Press the Start/Pause button to start the required
wash programme. The indicator lights "Washing"
and "Locked" comes on and the programme starts.
1
2
3
4
5
- 12 -