Preparation And Assembly Of The Door - Tricity Bendix BW 650 Operating And Installation Instructions

Building-in
P0965

Preparation and assembly of the door

The machine is originally pre-arranged for the assembly
of a door opening from right to left.
6
1
7
2
5
1
3
3
8
2
P0982
a) Door
The dimensions of the door should be:
- width 595-598 mm
- thickness 16-22 mm
The height (C-Fig. C) depends on the height of the adja-
cent furniture's base.
b) Hinges
35 Ø 14 depth
P0422
the centre of the hole depends on the adjacent furniture's
dimensions.
The required dimensions are given in the picture C.
The hinges will be fixed to the door by means of screws
for wood (2-Fig. B).
This appliance has been
designed to be built into
the kitchen furniture.
The recess should have
the dimensions shown in
picture A.
A
In this case it is sufficient
to screw in the hinges (1)
4
and the counter-magnet
(6) provided with the appli-
ance, at the right level (Fig.
B).
B
To mount the hinges it is
necessary to drill two holes
(dia. 35 mm, depth 14 mm)
on the inner side of the
door. The distance be-
tween the holes must be
416 mm.
The distance (B) from
C
upper edge of the door to
c) Mounting the door
Fix the hinges to the machine by means of the M5x8
screws (3-Fig. B). The hinges can be adjusted to com-
pensate for possible uneven thickness of the door.
To align the door perfectly it is necessary to loosen the
screw (3-Fig. B), adjust the door and tighten the screw
again.
d) Counter-magnet (6)
6
4
8
P0984
spond to the magnet (4) on the appliance (see picture D).
6
4
1
5
7
3
8
2
P1014
Important: the plastic screw (8) should never be loos-
ened (Fig. B and E).
The appliance is pre-
arranged for a magnetic
closure of the door. To
enable a correct operation
of this device, it is neces-
sary to screw the counter-
magnet (6) (steel disk +
rubber ring) into the inner
D
side of the door.
Its position must corre-
If the door has to be
E
opened from left to right,
invert the position of the
plates (7), the magnet (4)
and the rubber cap (5)
(Fig. B and E). Mount the
countermagnet (6) and the
hinges (1) as previously
described.
7