Cleaning The Filter; The Water Inlet Filters - Tricity Bendix BW 650 Operating And Installation Instructions

Cleaning the filter

The water drain filter
A clean filter is important for the correct functioning of the
machine, and should therefore be cleaned after every
washing and drying programme.
Open the filter door and place a container underneath to
catch any spillage. If the filter is blocked and the machine
is unable to drain you will need to drain the water manu-
ally from the machine at this stage. To do this, unhook
the drain hose from the standpipe or sink and hold the
end of the hose over a bowl on the floor. The water
should drain by gravity into the bowl. When the bowl is
full, hook the hose back up and empty the bowl. Repeat
the procedure until water stops flowing out.
Unscrew and remove the filter.
P0037
P0040
Warning
When the appliance is in use and depending on the pro-
gramme selected there can be hot water in the filter.
Never remove the filter during a wash cycle, always wait
until the appliance has finished the cycle, and is empty.
When replacing the filter, ensure it is securely retight-
ened so as to stop leaks and young children being able
to remove it.
P0039
Clean carefully under a
fast running tap.

The water inlet filters

If your water is very hard or contains traces of lime de-
posit, the water inlet filters may become clogged.
It is therefore a good idea to clean them from time to
time.
P0041
Turn off the water taps.
Unscrew the water inlet
hoses. Remove and clean
the filters using a hard
bristle brush. Replace the
filters and tighten up the
inlet hoses.
19