Inner Door Reversal - Zanussi ZDC76/4 Instruction Booklet

Fitting the furniture door to the appliance
Furniture door measurements:
Height= 1225 mm (Min.)
Width= 596 mm
Depth= 20 mm (Max.)
Position the runners (E) at the top and bottom of
the inside of the kitchen unit as shown in Fig. 7 and
mark the position of the external holes.
After preparing the holes, screw the runners to the
kitchen unit door using 3.5x16 mm screws.
E
D285
Open both the appliance door and that of the
kitchen unit to approx. 90 .
Place the little plates over the runners. Hold the
doors of the appliance and the unit together and
mark the holes.
8mm
PR34
Fig. 7
Fig. 8
Remove the little plates and make the holes with a
diam. of 2 mm. Replace the little plates over the
runners and screw in the screws provided
(3.5x16 mm).
For the alignment of the kitchen unit door, if
necessary, use the clearance size of the slotted
holes.
At the end of the procedure, check that the doors of
the appliance and the kitchen unit open properly.
PR35

Inner door reversal

Using a screwdriver release bracket (1) by pressing
on the internal spring (Fig. 10) and withdraw it
from its seat together with the door;
remove plug (2) and fit it in the hole left open on the
opposite side;
turn the door through 180 , remove the bracket (1)
and refit it on the opposite side.
Refit the door and insert the top pin and bottom
bracket (1), pushing it into place.
180°
2
PR140
To ensure correct storage of food, the door is fitted
with a simple spring device which holds it in the
open position until it is properly closed.
Fig. 9
Fig. 10
1
7