Zanussi WD1009 User Manual page 28

Problem
• Spinning starts late or the
laundry is not spun enough:
• The machine will not dry or the
laundry is not dry enough
Water is not
visible in the machine. The machine,
which is the result of modern technology, runs
in a very economical way with low water
consumption. Performance is
nevertheless excellent.
P1035UK
If you are unable to identify or solve the problem,
contact our service centre. Before telephoning, make
a note of the model, serial number and purchase
date of your machine: the Service Centre will require
this information.
Possible cause
• The electronic unbalance detection device has cut
in because the laundry is not evenly distributed in
the drum. The laundry is redistributed by reverse
rotation of the drum. This may happen several
times before the unbalance disappears and normal
spinning can resume. If, after few minutes, the
laundry is still not evenly distributed in the drum,
the machine will spin at a lower speed or will not
spin. If at the end of the programme the laundry is
not spun enough, redistribute the load manually
and select the spin programme.
• The water tap is closed (E10).
• The drain filter is clogged (E20).
• The drying time or degree of dryness has not been
selected.
• An appropriate drying time or degree of dryness
has not been chosen.
• There is too much laundry inside the appliance.
The machine makes an unusual
noise. The machine is fitted with a commutator
motor which improves machine
performance.
P1034UK
Mod. ..........
Prod. No. ...........
Ser. No. .........
P0042
55