Charging The Battery Pack; Ethernet Cradle/Cradle-Type Battery Charger; Car Adaptor - Casio V-T500 Series User Manual

Charging the Battery Pack

Battery pack installed in the tablet can be charged using either cradle, battery charger or
AC adaptor. Battery charge condition can be monitored with charge LED on the tablet.
Multiple battery packs can also be charged simultaneously using Dual Battery Charger.

Ethernet Cradle/Cradle-type Battery Charger

Align the mount holes in the tablet with the mount hooks on the cradle and fi t the tablet
into the cradle.
■
Status of Charge LED on V-T500:
Orange:
Red:
Blinking red: Standby due to being outside the temperature range for charging
Green:
* If, after 30 minutes or more at normal temperature, you plug the AC adaptor in again
and the charge LED is still red or off, there is a fault. Immediately stop using the
product and contact the dealer or distributor where you purchased the product, or an
authorized CASIO service provider.
* If the remaining battery change is 5% or less when the AC adaptor is connected
correctly, the charge LED turns off for approximately 0.5 seconds and then lights red.

Car Adaptor

Plug in the Car Adaptor to the cigarette lighter socket in vehicle.
■
Status of Charge LED on V-T500:
Refer to "Ethernet Cradle/Cradle-type Battery Charger" above.
Hook
Charging (battery level at 6% or more)
Battery level down to 0-5%
(until a level of 5%, tablet will not start up)
Battery pack error
(charging begins when the temperature is within the charging temperature range)
Charging complete
Hole
E-25