Echo 99944200418 Installation Instructions Manual page 2

2
b
lade
18
install metal shield
Tools Required: 8 x 10 mm Open-end Wrench, Screwdriver, T-
wrench, Torx T27 L-Wrench, Locking Tool
Parts Required: Metal Shield, Shield Bracket,
• 3 - 5 x 10 mm screws, (metal shield to gear hous-
ing).
• 2 - 5 x 8 mm screws, 2 - 5 mm nuts, 2 - 5 mm
lock- washers, (bracket to shield).
• 2 - 5 x 35 mm screws, 2 - 5 mm nuts, 2 - 5 mm
lockwashers (bracket to gear housing)
1. If installed remove nylon line head, upper fixing plate, shield plate,
and plastic shield.
a. Align locking hole in upper plate with notch in edge of gear
housing and insert head locking tool (A).
b. Remove line head (B) by turning it clockwise until head is
completely off of shaft.
c. Remove locking tool.
d. Remove three screws holding shield plate and plastic shield
(C) to gear housing.
e. Retain line head, upper fixing plate, shield plate, and plastic
shield for conversion back to nylon line head operation.
c
onversion
1
2
15
16
17
k i
it nstallation
3
3
4
14
13
12
11
9
10
i
nstructions
19
20
3
6
5
C
8
7
7
8
A
B