Clean/Adjust Spark Plug; Clean Spark Arrester; Cleaning - Baldor PC1100R Installation & Operating Manual

Clean/Adjust Spark Plug (Right side cover)
0.024 − 0.028 in.
(0.6 − 0.7 mm)

Clean Spark Arrester

Cleaning

Keeping the generator clean is an important part of good operation. If dirt buildup is not
removed, the generator will run hotter than normal and it's life is reduced. The following are
general guidelines for cleaning.
Maintenance Item
Check condition of AC Receptacles and GFCI operation
Check condition of Extension Cords
Check condition of DC terminals
Check condition of Engine Switch
Clean generator and check tightness of bolts and nuts.
Check engine oil level and replenish (to upper level) if
necessary.
Change engine oil (see Note 1)
Clean Spark Plug and set plug air gap
Replace Spark Plug
Clean Air Filter element
Replace Air Filter element
Replace Fuel Filter
Replace Spark Arrestor
Remove carbon from Cylinder Head (see Note 2)
Check and adjust Valve Clearance (see Note 2)
Clean and adjust carburetor (see Note 2)
Clean and replace Carbon Brushes
Replace Fuel Lines (annually)
Check condition of Rotor
Check condition of Stator
Replace Engine Mounts
Note 1: Initial oil change should be performed after 20 hours of operation and every 100 hours
Note 2: Please consult with Baldor Service for the correct procedures to follow for these items.
5-2 Troubleshooting and Maintenance
1. Remove the plug wire and spark plug.
2. .If the spark plug is contaminated, remove the carbon buildup with a plug cleaner or wire brush.
3. Adjust the electrode gap to 0.025 in. (0.6mm).
4. Install the spark plug and plug wire.
1. Remove the flange bolts from the muffler cover and remove the muffler cover.
2. Remove the screw that secures the spark arrester and remove the spark arrestor from the muffler.
3. Clean and remove carbon deposits from spark arrester with a wire brush. Be careful not to damage the
fine mesh screen material. Replace spark arrester if damaged (breaks or holes).
4. Install spark arrester in muffler and secure with screw.
5. Install muffler cover and secure with flange bolts.
1. Clean the generator set and remove any and all dust, dirt, or other foreign material.
2. Inspect and clean the cooling air intake and exhaust louvers of the generator end.
Make sure they are clean. Remove dirt or any buildup that may restrict the cooling air
flow.
3. Clean the generator set and its components with a damp cloth or sponge.
Never use a water hose or pressure washer as this may damage electrical
components.
4. Inspect and replace any control panel components that are broken or not working
properly (receptacles, circuit breakers, switches, etc.)
5. Inspect and clean all governor and carburetor linkages so they operate properly.
Table 5-1 Periodic Maintenance Schedule
8 Hours or
Daily
thereafter. Dispose of used oil properly at recycling center.
50 Hours or 100 Hours
Weekly
S
S
S
S
S
S
S
S
S
200 Hours or 500 Hours
Monthly
S
S
S
1000 Hours
S
S
S
S
S
S
S
S
S
MN2411