Checking And Adjusting The Throttle Cable - Yamaha 2008 SuperJet Owner's Manual

steering column, and then tighten it to the
specified torque.
1 Nozzle angles
1 Nozzle angles
2 Steering cable pivot bolt positions
Standard steering cable pivot bolt posi-
tion:
P2
NOTE:
Do not install the steering cable pivot bolt in
the outermost hole in the steering column.
Tightening torque:
Steering cable pivot bolt:
5.4 Nm (4.0 ft-lb) (0.55 kgf-m)
(5) Connect the steering cable joint to the
steering cable pivot bolt.
Maintenance and care
(6) Install the steering pole cover, and then
install the two screws.
EJU34361
Checking and adjusting the throttle
cable
Check that the throttle cable moves back to
the set position smoothly and that the throttle
lever free play is within specification.
Squeeze and release the throttle lever. If the
throttle lever does not return smoothly, have a
Yamaha dealer service it.
If the specified throttle lever free play cannot
be obtained as described below, have a
Yamaha dealer make the adjustment.
(1) Remove the four screws, and then re-
move the handlebar cover.
(2) Loosen the locknut.
(3) Adjust the free play by turning the adjust-
er.
1 Locknut
2 Adjuster
3 Throttle lever free play
62