Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Zanussi Electrolux ZGF 98
Summary of Contents for Zanussi Electrolux ZGF 98
-
Page 2: Important Safety Information
Important Safety Information These warnings are provided in the interest of safety. You read them carefully before MUST installing or using the appliance. It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred, always ensure that the book is left with the appliance in order that the new owner can get to know the functions of the appliance and the relevant warnings. -
Page 3: Table Of Contents
Contents For the Installer For the User Important Safety Information Instructions for the Installer Important safety requirements Description of the Hob Installation Operation Maintenance and Cleaning Conversion from LPG to Natural Gas Commissioning Something Not Working? Service and original spare parts Electrical connections Building In This appliance complies with the following... -
Page 4: Operation
Operation Hob burners To light a burner: turn the relevant control knob anticlockwise to the maximum position, then push it down to ignite the burner; then, check the flame is regular and adjust it as required. If you cannot light the flame even after several attempts, check the "cap"... -
Page 5: Maintenance And Cleaning
Maintenance and Cleaning Before any maintenance or cleaning can be carried out, you must DISCONNECT the hob from the electricity supply. The hob is best cleaned whilst it is still warm, as spillage can be removed more easily than if it is left to cool. -
Page 6: Something Not Working
Something Not Working? If the hob is not working correctly, please carry out the following checks before contacting your local Service Force Centre. SYMPTOM SOLUTION There is no spark when lighting the gas Check that the unit is plugged in and the electrical supply is switched on Check that the RCCB has not tripped (if fitted) Check the mains fuse has not blown... -
Page 7: Instructions For The Installer
Instructions for the Installer Engineers technical data OVERALL DIMENSIONS Rear Left Burner (semi rapid) Heat Input 2.0 kW Width: 860 mm Depth: 510 mm Front Left Burner (auxiliary) Heat Input 1.0 kW CUT OUT DIMENSIONS Rear Right Burner (semi rapid) Width: 830 mm Heat Input... -
Page 8: Important Safety Requirements
Important safety requirements This hob must be installed in accordance with the Gas FITTING THE GAS HOB Safety (Installation and Use) Regulations (Current Edition) WITHOUT A COOKER HOOD ABOVE and the IEE Wiring Regulations (Current Edition). Provision for ventilation 700 mm The hob should not be installed in a bed sitting room with a volume of less than 20 m . -
Page 9: Installation
Installation IMPORTANT: This hob must be installed by a competent person to the relevant Gas Standards. Any gas installation must be carried out by a competent person. The manufacturer will not accept liability, should the above instructions or any of the other safety instructions incorporated in this book be ignored. -
Page 10: Commissioning
Commissioning Pressure Testing When the hob has been fully installed it will be necessary to check the minimum flame setting. To do this, follow Remove left hand pan support and front left burner the procedure below. cap and crown. Turn the gas tap to the MAX position and ignite. Fit manometer tube over the injector. -
Page 11: Building In
Building In Building over a cupboard or Building over a kitchen unit with drawer door If the hob is to be installed above a cupboard or drawer it Proper arrangements must be taken in designing the will be necessary to fit a heat resistant board below the furniture unit, in order to avoid any contact with the bottom base of the hob on the underside of the work surface. - Page 14 35692-6601 05/06...