Building In - Zanussi Electrolux ZGF 98 Instruction Book

Building In

Building over a cupboard or
drawer
If the hob is to be installed above a cupboard or drawer it
will be necessary to fit a heat resistant board below the
base of the hob on the underside of the work surface.
It is also recommended to carry out the electrical
connection to the hob as shown in diagrams 1 and 2.
Dimensions are given in mm.
1
FO 2563
Fitting the Hob into the worktop
Carry out the building in of the hob as follows:
• place the seals supplied with the hob on the
side edges of the cut out and at 8 mm from the
front and rear edges, as shown in the diagram,
taking care that the seals meet without
overlapping;
• place the hob in the cut out, taking care that it
is centred;
• fix the hob with the relevant fixing clamps and
screws, as shown in the diagram. When the
screws have been tightened, the excess seal can
be removed.
The edge of the hob forms a double seal which prevents
the ingress of liquids.
Cut Out Size
The dimensions of the cut-out are given in the diagram.
Rectangular cut-out size for hob
Dimensions are given in mm.
FO 2349
Building over a kitchen unit with
door
Proper arrangements must be taken in designing the
furniture unit, in order to avoid any contact with the bottom
of the hob which can be heated when it is operated. The
recommended solution is shown in diagram 3.
The panel fitted under the hob ("a") should be easily
removable to allow easy access if technical assistance
is needed. The space behind the kitchen unit ("b") can
be used for connections.
2
F O
2564
3
FO 2044
Seal
a
FO 0199
21