Table of Contents
Advertisement
10 How to run a wash cycle
Permanent :
Hold down the "Temp." and "Option"
pushbuttons for a few seconds. The op-
tion is permanently activated, even if the
appliance is switched off. To deactivate
it, repeat the process.
"Delay start"
This option allows you to delay the start
of a wash programme by 3, 6 or 9 hours
by
pressing
the
pushbutton.
You can change or cancel the delayed
start time at any time before you press
the "Start/Pause" pushbutton, by pres-
sing the "Delay start" pushbutton again
(when all indicators are off, the wash
programme will start immediately).
If you have already pressed the "Start/
Pause" pushbutton and you want to
change or cancel the delayed start, pro-
ceed as follows :
• To cancel the delayed start and start
the cycle immediately, press "Start/Pau-
se" and then "Delay start". Press "Start/
Pause" to start the cycle.
• To change the timer delay period, you
must go through the "Off" position and
reprogram your cycle.
The lid will be locked during the delayed
start time. If you need to open it, you
must first pause the appliance by pres-
sing the "Start/Pause" pushbutton. After
closing the lid again, press the "Start/
Pause" pushbutton.
Start of the programme
It is normal for the programme selector
to remain stationary during the cycle.
Interrupting a programme
Adding washing during the first 10
"Delay
start"
minutes
Press the "Start/Pause" pushbutton :
the corresponding light will flash green
while the appliance is paused. The lid
can only be opened around 2 minutes
after the washing machine has come to
a stop. Press the "Start/Pause" pus-
hbutton again to continue the program-
me.
Modifying the programme in pro-
gress
Before making any changes to the cur-
rent programme, you need to pause the
washing machine by pressing the "Start/
Pause" pushbutton. If the modification is
not possible, the "Start/Pause" pus-
hbutton flashes red for a few seconds. If
you still decide to change the program-
me, you must cancel the current pro-
gramme (see below).
Cancelling the programme
If you want to cancel the programme,
turn the programme selector to the "Off"
position.
Press the "Start/Pause"
pushbutton to start the
cycle ; the corresponding
light will come on green.
The light corresponding
to the current cycle is
illuminated.
Advertisement
Table of Contents
