Water Inlet; Drain; Electrical Connection - Zanussi ZWT 3001 Instruction Manual

4. Water inlet

Please install the water inlet hose onto the back of your
washing machine:
The water inlet hose cannot be extended. If it is too short,
please contact the After Sales Department.

4.1. Drain

- Assemble the hose holder onto
the drain hose.
- Place the assembly in a drainage
pipe (or in a sink) at a height
between 70 and 100 cm. Make sure
that it will not fall out.
You must provide an air intake at the end of the drainage
hose, to avoid any water being siphoned.
Important: the drainage hose must not be extended, on
any account. If it is too short, contact a qualified engineer.

4.2. Electrical connection

You can only connect this washing machine to 230 V sin-
gle phase power supply.
Check rating of the fuse line: 10 A at 230V.
The washing machine must not be connected through an
extension cable or a power bar.
Check that the earthing connection is conform with the re-
gulations in force.
- Insert the seal in the hole at
the bottom of the back panel
(fig. 1).
- Screw on the bottom fitting of
the water inlet hose as shown
in fig. 2 and fig. 3.
- Connect the feed hose con-
nector onto the water inlet tap,
taking care to position the gas-
ket correctly.
- Turn on the water inlet tap.
30