Table of Contents
Advertisement
3. Mesh the rope stopper with the edge of the primary
sheave assembly.
1 Rope stopper
2 Primary sheave assembly edge
4. Wind the rope counterclockwise three turns on the
primary sheave assembly.
5. Grasp the screwdriver handle and pull briskly.
WARNING
@
Do not wind the emergency starter rope around your
hand.
@
6. After the engine starts, put the starter lever (choke) in
the half-open position. Warm up the engine until it
does not run roughly or begin to stall when the starter
lever is returned to the closed position.
7. Install the drive guard and shroud.
WARNING
@
Avoid contact with the moving primary sheave
assembly.
@
Electric starting model
For SXV60ER/VT60
Follow the procedures in the "Starting the engine" and
"Manual starting model" sections.
7-3
Advertisement
Table of Contents
