Yamaha RHINO YXR45FW Owner's Manual page 116

Installation
1. Measure the electrode gap with a wire
thickness gauge and, if necessary, adjust
the gap to specification.
Spark plug gap:
0.6–0.7 mm (0.024–0.028 in)
a. Spark plug gap
2. Clean the surface of the spark plug gas-
ket and its mating surface, and then wipe
off any grime from the spark plug
threads.
3. Install the spark plug and tighten it to the
specified torque.
Tightening torque:
Spark plug:
17.5 Nm (1.75 m·kgf, 12.7 ft·lbf)
NOTE:
_
If a torque wrench is not available when you
are installing the spark plug, a good estimate
of the correct torque is 1/4 to 1/2 turn past fin-
ger tight. Have the spark plug tightened to the
specified torque as soon as possible.
_
4. Install the spark plug cap.
5. Install the console.
8-22