WARNINGS It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings.
off frost or ice. Frost may be removed by using installation instructions. the scraper provided. Under no circumstances ¥ Parts which heat up should not be exposed. should solid ice be forced off the liner. Solid ice Wherever possible the back of the product should be allowed to thaw when defrosting the should be against a wall.
Freezing fresh food Cleaning the interior The 4-star compartment is suitable for Before using the appliance for the first time, wash long term storage of commercially frozen food, and the interior and all internal accessories with luke- for freezing fresh food. warm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry To freeze fresh foods It is not necessary to change...
Movable shelves The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. For better use of space, the front half-shelves can lie over the rear ones. D338 Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be placed at different heights.
each individual pack to enable you to keep tab of Hints for freezing the storage time; To help you make the most of the freezing process, ¥ on the inner door or special card (if supplied) you here are some important hints: will find sketches of various animals and food types together with the recommended storage ¥...
Defrosting Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates.
INSTALLATION Location The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. For safety reasons, minimum ventilation must be as shown in Fig. Appliance positioned under overhanging kitchen wall units (see Fig. A). Appliance positioned without overhanging kitchen wall units (see Fig.
Door reversibility 1. Unplug the appliance from the power supply before carrying out the below-mentioned operations. 2. Remove the bottom hinge (1).and feets (2+3) 3. Remove the bottom door and unscrew the middle hinge. 4. Remove the upper door by releasing it from the top hinge pin (D).