Warming Up Engine - Yamaha VZ150C Owner's Manual

ON
START
OFF
701022
EMU00949
Electric Start Model
7) Turn the main switch to "START",
and hold it for a maximum of 5 sec-
onds.
8) Immediately after the engine starts,
release the main switch to return it to
"ON".
cC
8 Do not turn the main switch to
"START" when the engine is running.
8 Do not keep the starter-motor turning
for more than 5 seconds. The battery
will rapidly become exhausted and it
will be impossible for it to start the
engine. If the engine does not start
within 5 seconds, return the main
switch to "ON", wait 10 seconds, and
then crank the engine again.
EMU01198

WARMING UP ENGINE

1) Before beginning operation, allow the
engine to warm up at idling speed for
3 minutes. (Failure to do this will
shorten engine life.)
2) Check for a steady flow of water from
the cooling-water pilot hole.
cC
A continuous flow of water from the pilot
hole shows that the water pump is
pumping water through the cooling pas-
sages. If water is not flowing out of the
pilot hole at all times while the engine is
running, do not continue to run the
engine. Overheating and serious damage
could occur. Stop the engine and check
to see if the water inlet on the lower cas-
ing is blocked. If the problem cannot be
309034
found and
Yamaha dealer.
3-14
corrected, consult
E
your