Yamaha V-stan 1300 Owner's Manual page 24

INSTRUMENT AND CONTROL FUNCTIONS
Right
3
1. Engine stop switch "
2. "SELECT" switch " /
3. "RESET" switch
4. Start switch " "
Dimmer switch "
Set this switch to "
beam and to " " for the low beam.
Turn signal switch "
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
leased, the switch returns to the center
position.
Since this model is equipped with a
self-canceling system, the turn signal
lights will self-cancel after the vehicle
has traveled both about 150 m (490 ft)
and for approximately 15 seconds.
However, the turn signal lights can also
be canceled manually by pushing the
switch in after it has returned to the cen-
ter position.
NOTE:
The self-canceling system only oper-
ates when the vehicle is moving, so that
the turn signal lights will not self-cancel
/ "
while you are stopped at an intersec-
"
tion.
Horn switch "
EAU12400
/ "
Press this switch to sound the horn.
" for the high
Engine stop switch "
Set this switch to "
EAU12430
/ "
the engine. Set this switch to "
stop the engine in case of an emergen-
cy, such as when the vehicle overturns
". When re-
or when the throttle cable is stuck.
Start switch "
Push this switch to crank the engine
with the starter.
CAUTION:
See page 5-1 for starting instruc-
tions prior to starting the engine.
The engine trouble warning light will
come on when the key is turned to "ON"
and the start switch is pushed, but this
does not indicate a malfunction.
"SELECT" switch "
This switch is used to perform selec-
tions in the odometer, tripmeter and
EAU12500
clock mode of the multi-function meter
"
unit.
See "Multi-function meter unit" on page
3-3 for detailed information.
EAU12660
/ "
" before starting
"RESET" switch
" to
This switch is used to perform selec-
tions in the odometer, tripmeter and
clock mode of the multi-function meter
unit.
See "Multi-function meter unit" on page
EAU12710
"
3-3 for detailed information.
3-7
ECA10050
EAU41700
EAU42522
/ "
EAU42531