Table of Contents
Advertisement
General setup
1
Press MENU to enter SETUP MENU
2
Use
/
/
/
to select your preferred option.
3
Press ENTER to confirm a highlighted selection.
4
To exit setup menu, press MENU.
Setting the picture
* TV Shape
Select the aspect ratio of the TV to be connected.
4:3 PS (default setting)
-
If you have a conventional TV set and your DVD is not
formatted for widescreen viewing, use this setting. A wide picture
is displayed on the whole TV screen with a portion
automatically cut off.
4:3 LB
-
If you have a conventional TV set and your DVD is formatted for
wide screen viewing, use this setting. Wide bands will be
displayed on the upper and whole portions of the TV screen.
16:9
-
If you have a widescreen TV set, use this setting (you must also
set your widescreen TV to "full size").
16:9
(Wide screen)
4:3 LB
(Letter Box)
4:3 PS
(Pan Scan)
Note
If your DVD is not encoded to allow you to change the aspect
ratio, TV shape cannot be changed.
* TV System
Allows you to select the color system matching the connected
TV set.
AUTO
-
If the connected TV is multi system, select this mode. The
output format will be in accordance with the video signal of the
disc.
Special Functions
NTSC
-
If the connected TV is NTSC system, select this mode. It will
change the video signal of a PAL disc and output in NTSC format.
PAL
-
If the connected TV is PAL system, select this mode. It will change
the video signal of a NTSC disc and output in PAL format.
* Video Out
Video out selection enable you to choose the type of video out put
suitable for your receiver.
PR PB Y
-
Select PR PB Y, if you have connected the video output to your TV
using S-VIDEO jack.
SCART
-
Select SCART, if you have connected the video output to your TV
using the Scart jack.
* Screen Saver
If set to ON, when you leave the system in stop or pause mode for
more than one minute, the screen saver will be activated.
Setting the sound
* Digital Output
Digital output selection enables you to specify the type of digital
output suitable for your amplifier or receiver.
-
Select ALL, if you have connected the digital output (COAXIAL or
OPTICAL) to a multichannel decoder receiver.
-
Select PCM 96K if the external component is capable of
processing digital signal input with sampling rates of 96 kHz.
-
Select PCM 48K if the external component is incapable of
processing 96kHz digital signal input, then convert to standard
signal with sampling rates of 48 kHz.
-
Select OFF to deactivate the digital output (COAXIAL or
OPTICAL).
* Night Mode
Set night mode to on to lever out the volume. For example, the disc
will be play at the same sound level throughout the movie. The
default setting is OFF.
-
Center Delay
If the listening position is close to the center speaker than the front
speakers, you can set the center delay time to improve the
surround sound effect.
Options: OFF (default setting), 1ms, 2ms, 3ms, 5ms.
-
Rear Delay
If the listening position is closer to the rear surround speakers than
the front speakers, you can set the rear delay time to improve the
surround sound effect.
Options: OFF (default setting), 3ms, 6ms, 9ms, 12ms, 15ms.
-
Test Tone (Disc mode only)
If set to ON, the system will test the speaker setting. The test signal
is generated through the left, center, right and surround speaker.
The default setting is OFF.
9
Advertisement
Table of Contents
